
Page 4/9
Safety Data Sheet
Trade name: Moldex Deep Stain Remover (HE)
(
C
o
n
t
d
.
o
f
p
a
g
e
3
)
SECTION 8: Exposure controls/personal protection
·Additional information about design of technical facilities: No further data; see item 7.
·8.1 Control parameters
·Ingredients with limit values that require monitoring at the workplace: The product does not contain any
relevant quantities of materials with critical values that have to be monitored at the workplace.
·DNELs No further relevant information available. ·PNECs No further relevant information available. ·Additional
information: The lists valid during the making were used as basis.
·8.2 Exposure controls ·Personal protective equipment: ·General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals. Keep away from foodstuffs,
beverages and feed. Avoid contact with the eyes. Avoid close or long term contact with the skin.
·Respiratory protection: Not required under normal conditions of use. For large spills, respiratory protection may
be advisable.
·Protection of hands:
Protective gloves
Wear protective gloves to handle contents of damaged or leaking units. The glove material has to be impermeable
and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the
penetration times, rates of diffusion and the degradation.
·Material of gloves The selection of the suitable gloves does not only depend on the material, but also on further
marks of quality and varies from manufacturer to manufacturer. As the product is a
preparation of several substances, the resistance of the glove material cannot be calculated
in advance and has therefore to be checked prior to the application.
·Penetration time of glove material The exact break through time has to be found out by
the manufacturer of the protective gloves and has to be observed.
(Contd. on page 5)
Komentarze do niniejszej Instrukcji